Proyect Overview

Financiador

horizon 2020

Número de expediente: SP1-JTI-CS-2013-03
Programa: Clean Sky

Partners

  • AERTEC SOLUTIONS SL (Coordinador)
  • SERVICIOS DE TECNOLOGIA INGENIERIA E INFORMATICA SL

Resumen

The current project is for the design and development of Thermal and Electrical Mock-ups for the validation of the thermal behaviour in the electrical air systems architecture at aircraft level.
The electrical systems architectures for future aircraft include high density power electronics that works at a higher voltage value and produces correspondingly high point heat loads which have to be electrically and thermally managed in the most efficient way.

The related mock-ups will be dedicated to the Thermal Management of the AVANT ground demonstrator located at the ‘Centre of Applied Aeronautical Research’ in Hamburg.

Therefore, TEMGIR will be focused to obtain an optimum rate between consumed and re-generated power to build reducing consumes and CO2 emissions.

TEMGIR will provide a thermal model of aircraft with both electrical and thermal behavior which will be able to develop any relevant condition and scenarios within different flight phases. The electrical equipment provided has a thermal response based on its power supply which will be governed and monitored by Control and Monitoring Sw System. The Software will load the scenario and equipment profile to simulated according on flight phase, location in aircraft, special situations.

Papel de Ceit en el proyecto

CEIT is in charge of the design inside of this project of all the Electrical Active Loads that will be necessary in order to evaluate all the systems that are not physically available in the Test Ring. These active electrical loads can be divided into two different stages:

  • All the voltage stabilization systems that are necessary in order to adapt all different voltage levels that will be available in the Power supply system. These devices are based in a complex mixture of electromagnetic transformers, controlled and non-controlled rectifiers and voltage controlled DCDC converters.
  • All the programmable current loads that simulates the virtual power consumptions. These programmable current loads are based on current controlled DCDC power converters.

Finally, CEIT is in charge of the design of a Power regenerating module able to re-inject up to 70 kW to the electrical grid of the ‘Centre of Applied Aeronautical Research’ during the electrical emulation. This will allow to increase the energetic performance of the overall system.

Persona de contacto

José Martín Echeverría

José Martín Echeverría

Email: This email address is being protected from spambots. You need JavaScript enabled to view it.